山东鼎胜制冷设备有限公司
地址:济南天桥区粟山路泉利重配城
全国咨询热线:400-096-6610
电话:0531-85968762
手机:13075373251
联系人:邓老师
当前位置:首页-新闻资讯-公司动态
公司动态
冷库组件蒸发器的安装规范
2016-3-8 11:58:58
冷库组件蒸发器的安装规范
The installation of cold storage components evaporator specification
安装内容:先把吊装螺丝孔开好,并开好铜管及电线孔,后二孔要修整以防快口留下隐患,自配排水管的蒸发器背面与立板定位为 300MM ,蒸发器排水孔与立板预先安好的排水孔位垂直,两者间高差为 250MM 。
Install content: the lifting screw holes open first, open good copper pipe and wire hole, and after two hole to repair in case of quick mouth left hidden trouble, since with a drain on the back of the evaporator and vertical plate positioning is 300 mm, the evaporator drain and vertical plate be just fine a vertical drain holes in advance, elevation difference between is 250 mm.
如是冷冻库,排水管内穿排水电热丝,排水电热丝发热部位,只能伸到库板内 50MM 处,排水管外部保温处理,冷藏不需电热丝,其它相同。食品冷库
Heating wire, the freezer, the drainage tube wear drainage, drainage heating wire heating parts, can only be stretched to the base plate within 50 mm, drainage pipe external heat preservation processing, cold storage without heating wire, the other is the same.
吊装注意:蒸发器进风口不能对着库门,蒸发器最好吊放在冷库最长端,蒸发器出风口最好不要对着门,(蒸发器取位居中,以便维修)。
Hoisting note: evaporator air inlet can't to the door, evaporator best hanging on the side, the longest refrigerator evaporator outlet had better not to the door, (evaporator in the, in order to repair).
在线咨询