山东鼎胜制冷设备有限公司
地址:济南天桥区粟山路泉利重配城
全国咨询热线:400-096-6610
电话:0531-85968762
手机:13075373251
联系人:邓老师
当前位置:首页-新闻资讯-行业动态
行业动态
冷库机组蒸发器的安装规范事项
2015-12-18 13:47:03
冷库机组蒸发器的安装规范事项:
The installation of cold storage unit evaporator specification items:
1、冷库机组铜管排放全部铜管需作别穿保暖管与同方向电一重新任用空调扎带一块儿绑扎好,尽力走直管并分段固定。
1, cold storage units into the pipe emissions all need to wear warm tube with the same power over reinstating air conditioning tie binding together well, try to walk straight and fixed.
2、电排放全部电除用空调扎带扎好外,需用斑纹软管或走槽穿管尽力照顾,温度显露导尽力不与电靠在一块儿排。
2 electrical use air conditioning, electric discharge all cable tie fasten, using speckle hose or go trough wear tube try our best to take care of, temperature show guide to row with electricity on.
3、冷库机组安装冷库机组位置离蒸发器越近越好,且易维修,散令人满意,如外移需安装遮雨棚,冷库机组位四角需求安插防震垫片,安装水准坚固,不易被人碰着。
3, cold storage system with cold storage installation position as close to the evaporator, the better, and easy maintenance, satisfactory, such as offshoring need to install the canopy, the cold storage unit corners needs installing shockproof washers, installation level is strong, not easy to be touched.
4、、把吊装螺钉孔开好,并开好铜管及电孔,后二孔要修整以防快口留下隐患,自配排水管的蒸发器背面与立板定位为300,蒸发器排水孔与立板预平安的排水孔位铅直,两者间高差为250,如是速冻冷库,排水管内穿排水电丝,排水电丝发部位,只能伸到库板内50处,排水管外部保暖处置,冷藏不需电丝,其他相同。
4, and the lifting screw hole is good, and good copper pipe and electric hole, after the second hole to repair in case of quick mouth left hidden trouble, since with a drain on the back of the evaporator and vertical plate positioning for 300, evaporator and drain board scupper a straight, in the process of the peace between the elevation difference is 250, so frozen cold storage, the drainage tube wear drainage electric wire, drainage electric wire location, only to 50 libraries the plate and the drain external thermal disposal, refrigeration without electric wire, the other is the same.
在线咨询